Desk Placement - Uplift Desk T-Frame Manual

When moving the desk, if casters are not installed, use a two-person lift and lift the desk so that it can be
moved without dragging. Dragging the desk may cause the frame and screws to pull loose from the desktop.
When moving the desk, DO NOT lift the desk by the desktop alone. Support both the frame and the desk-
top equally. Favoring one over the other can stress the fasteners connecting the desk frame to the desktop.
Lower the desk completely before moving it.
Choose a placement for the desk that's a safe distance from window frames, radiators, furniture, etc., so that
people do not get stuck or trapped by the desk, and nothing obstructs the desk from rising or lowering.
Ensure adequate cord clearance before using the desk. Connect desk's power cord to the 120v outlet to
make the desk ready for use.
Do not place any objects underneath the desk that are taller than 20''.
8
© UPLIFT Desk • 1-800-349-3839 • 1-512-614-3152 • info@upliftdesk.com • upliftdesk.com
Step 11
Grab a friend to turn the assembled desk right-side
up. Be sure to support the desktop and the frame
equally to limit stress on the screws.
After turning the desk over, adjust the Leveling studs
or casters as needed to make the desk level.
NOTE: Make sure no obstacles are in the
!
desk's path. Make sure cords are a length
that will accommodate the change in height.
Step 12
Plug the power cable (C8) into the Control box (C6),
and then into a 120v wall outlet.
IMPORTANT! You must RESET the desk prior to
use (or if you change out the control box)! Hold the
DOWN button on the Keypad until the desk reaches
its lowest height, then release. Hold the DOWN but-
ton again for about 10 seconds*. Then hold the DOWN
button a third time until the desk lowers a little bit
more, slightly rises, then stops, then release. Your desk
has been reset, and is now ready to use.
*If you have the Advanced Digital Memory Keypad,
the digital display will flash "RST" when you press the
DOWN button a second time. For more programming
options with the Advanced Digital Memory Keypad,
refer to the "Programming" section on pages 9 thru 11.

DESK PLACEMENT