Advertisement
D. Carefully position the frame so that the three holes
in each Side Bracket align with the metal threaded
inserts along the sides of the desktop.
E. Loosely insert three of the #10-24 x 3/4" Machine
Screws (H5) with #10 Flat Washers (H6) through the
holes in the Side Brackets and into the threaded
metal inserts at the sides of the desktop using a
Phillips head screwdriver. Do not tighten them yet.
F. Loosely insert two more #10-24 x 3/4" Machine
Screws with #10 Flat Washers through each Cross
Brace near the center of the frame between the
Crossbar Rails and into the metal threaded inserts.
Do not tighten them yet.
G. Once all eight screws have been started, tighten
them the rest of the way. Be careful not to
overtighten the screws to prevent stripping.
H. Line up the Control Paddle with the threaded holes
in the Control Paddle Adapter (C8) and attach it
with two M6 x 6 Machine Screws (H2) using the
4mm Allen Wrench (H8).
I. Feed any excess cable back into the cutout in the
Crossbar Rail. Be careful not to let the cable bind or
kink.
Step 10 - Cover Attachment
A. Place the Cover (C9) on the frame as shown.
B. Loosely attach the Cover with six M6 x 10
Machine Screws (H1).
C. When all the screws are started, tighten them
using the 4mm Allen Wrench (H8).
10
Advertisement
