Advertisement
A C C E S S O R Y I N S TA L L AT I O N : B E A M S H A P E R
1. Place fixture on the stable flat surface and let cool for 15mins.
2. Align Beam Shaper onto front lens so that the indentation on the inner edge of the beam
shaper is aligned with the small gear at the front of the lens. This should also result in the
4 screw holes on the beam shaper being correctly aligned with the 4 screw holes on the
fixture.
3. Carefully, using a hand screwdriver, insert/secure included 4 screws.
4. Check Beam Shaper to confirm it is seated properly and all 4 screws are secure.
DO NOT OVER TIGHTEN SCREWS! DO NOT USE A POWER SCREWDRIVER!
14
Advertisement
