Advertisement
E R R O R C O D E S
ERROR CODES
PAN
Tilt
Zoom
Beam Shaper
Barndoor
LED Temp
LED FAN
BASE FAN
Error Codes subject to change without notice
Movement is not located in the default position after the reset.
These messages will appear after a fixture reset if the magnetic-indexing circuit
malfunctions (sensor failed, or magnet is missing) or there is a motor failure (defective
motor or a defective motor IC drive on the main PCB). This error may also be displayed if
the head/yoke was blocked during a reset function.
Movement is not located in the default position after the reset. These messages will
appear after a fixture reset if the magnetic-indexing circuit malfunctions (sensor failed,
or magnet is missing) or there is a motor failure (defective motor or a defective motor
IC drive on the main PCB).
These messages will appear if there is a temperature and/or fan malfunction.
DESCRIPTION
33
Advertisement
