Advertisement
A C C E S S O R Y I N S TA L L AT I O N : S N O O T
NOTE: During normal operation, this unit is intended to work at all times with
the Snoot installed.
To install either the Beam Shaper or Barndoor, it will be necessary to remove the Snoot.
1. Place fixture on a stable flat surface and let cool for 15mins.
2. Using a hand screwdriver, remove 4 screws.
3. Carefully remove and set aside Snoot in safe location.
If either accessory is removed, it will be necessary to reinstall Snoot:
1. Place fixture on the stable flat surface and let cool for 15mins.
2. Align Snoot onto front lens, making sure that the indentation on the inner edge of the snoot
is aligned with the gear on the front of the unit. This should also result in the 4 screw holes
on the snoot being correctly aligned with the 4 screw holes on the fixture.
3. Carefully, using a hand screwdriver, insert/secure included 4 screws.
4. Check Snoot to confirm it is seated properly and all 4 screws are secure.
DO NOT OVER TIGHTEN SCREWS! DO NOT USE A POWER SCREWDRIVER!
13
Advertisement
