Checking The Water Inlet Filter And Replacing The Gasket - Hanseatic HWMK814A User Manual

Page EN-30 Care and maintenance
Checking the water inlet filter
and replacing the gasket
There are filters in the appliance's water inlet
which
prevents foreign particles from entering the
appliance.
• Check and clean the filter every 3 months
or if the appliance is not getting enough
water despite the tap being open com-
pletely.
NOTICE
Risk of damage to property!
Improper handling of the appliance
may result in damage.
■ Turn off the water intake tap after
each use, before cleaning the water
intake fi lter or replacing the seal. Oth-
erwise there is a risk of water dam-
age.
■ Close the valve before cleaning the
fi lter or replacing the gaskets.
■ Check and clean fi lters and gaskets
regularly.
■ Replace defect fi lters and gaskets im-
mediately. Never operate the appli-
ance without fi lters and gaskets.
1. Switch off the appliance, take the mains
plug out of the socket and turn off the tap.
2. Unscrew the water inlet hose (32) from
the valve.
3. Clean the filter with a small brush.
4. Screw the water inlet hose onto the valve
again.
5. Unscrew the water inlet hose from the ap-
pliance.
6. Pull out the union nut (37) with strainer.
(35)
(36)
(37)
7. Use tweezers or a pair of pliers to pull the
filter (35) with gasket (36) out of the un-
ion nut (37). Rinse the filter under fresh
water and clean with a small, soft brush
if necessary.
8. Re-insert the filter and screw the water
inlet hose back onto the appliance.
9. Open the valve to check whether the hose
and connections are sealed.
(27)
(37)