Checking The Water Inlet Filter And Replacing The Gasket - Hanseatic HWMK914B User Manual

Page EN-28 Care and maintenance
Checking the water inlet filter
and replacing the gasket
NOTICE
Risk of damage to property!
Improper handling of the appliance
may result in damage.
■ Turn off the water intake tap after
each use, before cleaning the water
intake fi lter or replacing the seal. Oth-
erwise there is a risk of water damage.
■ Close the valve before cleaning the
fi lter or replacing the gaskets.
■ Check and clean fi lters and gaskets
regularly.
■ Replace defect fi lters and gaskets im-
mediately. Never operate the appli-
ance without fi lters and gaskets.
There are filters in the appliance's water inlet
which prevents foreign particles from entering
the appliance.
Check and clean the filter every 3 months or
if the appliance is not getting enough water
despite the tap being open completely.
1. Switch off the appliance, take the mains
plug out of the socket and turn off the tap.
2. Unscrew the water inlet hose from the valve.
3. Clean the filter with a small brush.
4. Screw the water inlet hose onto the valve
again.
5. Unscrew the water inlet hose from the
appliance.
(23)
(24)
(25)
6. Use tweezers or a pair of pliers to pull the
filter (23) with gasket (24) out of the union
nut (25). Rinse the filter under fresh water
and clean with a small, soft brush if nec-
essary.
7. Re-insert the filter and screw the water
inlet hose back onto the appliance.
8. Open the valve to check whether the
hose and connections are sealed.
(16)
(23)