Table of Contents
Advertisement
Installation (cont.)
Uncrating
Tools Required
• Adjustable wrench
• Phillips screwdriver
• Level
The following procedure is recommended for uncrating the unit:
1. Remove the outer packaging (cardboard and bubble wrap
or Styrofoam corner and clear plastic). See fig. 1. Inspect for
concealed damage. Again, immediately file a claim with
the freight carrier if there is damage.
NOTE: DO NOT remove shipping blocks (see fig. 2) until the
unit is installed in its final location. Do not discard; use the
blocks when next moving the cabinet.
2. NOTE: Remove the clips securing the cabinet to the skid
(see fig. 3). Move the unit as close as possible to the final
location before removing the wooden skid. Some models may
require removing the front and/or rear grill/cover to access the
shipping bolts.
3. If leveling legs or castors will not be used, remove the
cabinet from the wood skid and set the skid aside.
NOTE: DO NOT lift the cabinet by the countertops, doors,
drawers, or grills.
If leveling legs or castors will be used, rotate the cabinet on
the skid (see fig. 4) and see the installation instructions on
page 6.
NOTE: Remember to leave cabinet upright for 24 hours before
plugging into a power source. Keys for cabinet with door locks are
located in the warranty packet.
Fig. 3. Pallet clip locations. Not all sides shown.
WARNING
– Units may pose a tipping hazard
while uncrating, during installation, or when
moving the unit.
TEC_TM_122 | REV. A | EN
TCGG
Fig. 1. Remove the exterior packaging.
Fig. 2. Glass slide door shipping block locations. Remove if so
equipped and do not discard.
Fig. 4. When lifting unit, do not use countertops, doors/drawers,
or grills as a lifting point.
03/24/2021
truemfg.com
Page 5 of 18
Advertisement
Table of Contents
