Assembly Steps - True STRYKER ST1000 Owner's Manual

ASSEMBLY STEPS

Step 1—Attach the Pedestal Upright Assemblies
A. On the right side of the machine, fully route the
Power, I/O Communication, Network, and Coaxial
cables from the base through the opening on the
lower right pedestal upright assembly.
IMPORTANT! Confi rm cable slack in the base will
not interfere with the moving belt treads.
B. Using the M10 lock washers and M10 hex bolts,
fi nger tight the left and right pedestal upright
assemblies to the base.
NOTE: You will not fully tighten the hardware until
step 6.
C. Connect the Power, I/O Communication, Network,
and Coaxial cables from the base to the Power, I/O
Communication, Network, and Coaxial cables inside
the right pedestal upright assembly.
D. Verify all cables have been securely connected and
then carefully tuck all cables back inside the right
pedestal upright assembly.
IMPORTANT! Verify cables are carefully tucked in
the right upright pedestal and DO NOT get pushed
back into the base as this might cause them to be
damaged by the slat belt.
B
3
2
1
4
B
D
Item Part Number
1 FE0091 HEX SOCKET BOLT, M10X1.5X20
2 FE0090 SPLIT LOCK WASHER, M10
PEDESTAL UPRIGHT ASSEMBLY,
3 ST1009L
PEDESTAL UPRIGHT ASSEMBLY,
4 ST1009R
DO NOT PUSH CABLES BACK
INTO THE BASE AS THIS MIGHT
CAUSE THEM TO BE DAMAGED
Description
LEFT
RIGHT
A
C
D
BY THE SLAT BELT
QTY
12
12
1
1
15