Assembly Steps - True TPS800-5 Owner's Manual

CHAPTER 2: ASSEMBLY INSTRUCTIONS
TREADMILL ASSEMBLY STEPS:
CAUTION:
• Use caution when assembling treadmill. Unpacking
and assembling of this treadmill is a two person task.
•
Remove all treadmill components from packaging.
1. Remove 9 bolts (m), Left and Right motor
decoration covers and upper motor cover.
2. Slip the left and right upright (C, D) into
place.
3. Connect the wire of left upright (C) as the
arrow shows in the drawing 1-1.
4. Install, but do not tighten, 8 bolts and
washers (a,d) into each upright.
5. Place the console on the uprights and fasten
it with 4 SEMS bolts (b). Place 4 bolt covers
(c) into holes of console as shown.
6. Connect the lower control wire coming out
of left upright with the upper control wire
attached in the console, then fasten the wire
cover (j) with 2 bolts (e) to the upper console
cover.
7. For each upright, tighten Hex Head bolt
against upright. Then tighten nut.
8. Reinstall the upper motor cover, place the
left and right motor decoration cover into
place, and fasten with 9 bolts (m) as shown.
Truefitness.com / 800.426.6570 / 636.272.7100 11