Table of Contents
Advertisement
TENSIONING THE SLAT BELT
1. Using a #2 Phillips screwdriver, remove the front roller covers and side straddle covers.
2. Using an 8mm allen wrench or socket wrench with hex bit, turn both adjustment bolts clockwise ¼ turn, alternating
between the left and right bolts.
3. Measure the vertical distance between the top and bottom of the slat belt assembly at the midspan confi rming a
measurement of 10-¼" (26 cm).
IMPORTANT! When measuring, do not pull up on the tape measure. Pulling up can cause the measurement to
be off . Just rest the tape measure in place to achieve the most accurate reading.
NOTE: You might need to go back and forth between the right side and left side a few times. Adjusting one side
aff ects the other side, and you want to be sure both sides measure 10-¼" (26 cm).
4. Reattach the side straddle covers and front roller covers.
5. Turn the treadmill ON (
smoothly.
NOTE: If a slipping, skipping, or jerking sensation is present, check the drive belt. The drive belt is separate from the slat
belt. If the drive belt is slipping you will need to replace the drive belt. Contact TRUE product support.
25
ll
3
6
8
10 12
SPEED
5
power
ON/OFF
switch
5
) and start the belt at 3mph (5kph). Keep off the unit to verify the slat belt is rotating
2
2
top
3
bottom
3
37
Advertisement
Table of Contents
