Table of Contents
Advertisement
Promix-SM305
Lock and latch overall and mounting dimensions.
6. INSTALLATION AND CONNECTION
6.1 LOCK AND LATCH MOUNTING
1. Drill a hole for lead-out of the power wire at the place of the lock installation.
2. Lay the power wire through the hole produced inside the shape slot and lead it to outside by
drilling the shape.
3. Apply the catch to the fittings slot of the door frame and fix it with self-tapping screws 4.
4. Using a knife or a chisel, remove two projections 12-14 mm long in the door frame shape
(see Fig.5).
Door frame
12-14
.
Fig. 5
5. Insert the plate with the latch 2 in the slot of the door section so that the roller is at the center
of the lock slot (if the door shape slot is occupied with fittings, then the latch is mounted
without the base (see Fig.6).
4
Fig.3
Latch base
Adjustment plate
Fig. 6
Fig.4
Door
60-70.
Fig. 7
Advertisement
Table of Contents
