Table of Contents
Advertisement
Promix-SM308
6. INSTALLATION AND CONNECTION
6.1 LOCK AND LATCH MOUNTING
1. Screw out the screw on the front surface of the lock and remove the cover.
2. Mount the lock on a wall, at a distance of 15mm from the locker wall edge.
Locker wall
edge
Fastening self-tapping screws
3. Connect the lock to the power supply (see
4. Insert the latch into the lock.
5. Test operability of the lock – as voltage is applied, the lock must push out the latch.
6. Fasten the latch to the door at a distance of 20±3mm from the base edge of the lock (see
Fig. below).
7. Test operability in door closing.
4
15
6.3).
Base edge of
the lock
3 holes
Advertisement
Table of Contents
