Advertisement
Wings Assembly
5. Remove black rubber ring from the wing side,pass
aileron servo wire into the black rubber ring and
secure it to the original position.
6. Secure aileron servo arm and control horns with ball head
pull rod, put the cup head hexagonal screw, gasket, ball head
on servo arm, secure it with iron pliers, adjust the ball head
pull rods to proper length.
7. Secure screw, washer, ball head to control arm, control arm is
at 90 degrees against servo.
8. Check the degrees between servo arm and control arms.
Zhuhai Edge Smart Drive Technology Co., Ltd.
www.omphobby.com
Advertisement
