Additional Functions - Hanseatic HWM5T110D User Manual

Page EN-18 Washing
If no further settings are made, the appliance
will automatically switch off after 15 minutes.
The spin speed affects the noise
emissions of the appliance and the
residual dampness of the laundry.
The higher the spin speed, the higher the
noise emissions and the lower the residual
dampness.

Additional functions

Start time preselection
The cycle usually starts as soon as you have
pressed the "Start/Pause" button (7).
The appliance, however, offers you the option
to delay the start time. The delay can be set
in one-hour increments. The maximum delay
time is 23 hours.
1. Select the desired cycle using the cycle
selector (2).
2. Press the "Start time preselection" but-
ton (6).
"1h" is shown in the display (3), i.e. the se-
lected cycle will start in one hour.
3. Press the "Start time preselection" but-
ton (6) repeatedly until the desired delay
time is set.
4. Press the "Start/Pause" button (7).
The cycle will start after the delay setting
has elapsed.
Terminate delay
If you have already pressed the "Start/Pause"
button (7),
• press the "Start time preselection" but-
ton (6) .
The cycle will now start.
• If you have not yet pressed it, press the
"Start time preselection" button (6) re-
peatedly until the delay time is no longer
shown in the display (3).
Button lock
The button lock allows you to secure the ap-
pliance from unwanted use of the buttons.
You can activate the safety lock only if you
have previously selected a cycle.
Activating button lock
(2) (3)
Aus
Extrakurz 15' Baumwolle
Anzeige
Kurz 60' Eco 40-60
Jeans/ Baumwolle
Dunkle Kleidung
Mix Baumwolle
20°C
Sport /
Buntwäsche
Pflegeleicht
Hand-/
Wolle
Feinwäsche
Schleudern/Abpumpen / / Spülen
Allergie
• Simultaneously hold both "Spin" (5) and
"Start time preselection" (6) buttons until
the "CL" signal appears in the display (3).
Now if any button is pressed or the cycle
selector (2) is turned, it will have no effect.
The "CL" signal now flashes in the dis-
play (3).
Deactivating button lock
• Simultaneously hold both "Spin" (5) and
"Start time preselection" (6) buttons until
the "CL" signal appears and flashes in the
display (3).
If the "CL" signal disappears after a few
seconds, the button has been deactivated
again.
(5) (6)
Funktionen e en
Startzeit-
Temp. Schleudern vorwahl
Start /
Pause