Hanseatic HWMK814B User Manual page 88

Page EN-40 Troubleshooting table
Problem
Detergent contains bleaching
Colours of the
agent.
laundry have
Stain remover or similar was
faded.
used.
Problem
Mains plug is not sitting
properly in the socket or is not
Appliance does not
plugged in.
work.
Socket has no voltage.
Fuse is not intact.
No wash cycle set.
Loading door is not closed
properly.
Wash cycle does
Cycle was not started.
not start.
The appliance calculates the
amount of laundry (approx.
1 minute).
Valve is closed.
Loading door is not closed
properly.
There is a kink in the water
Appliance is not
inlet hose.
receiving water.
The water inlet hose is
clogged.
Filter on inlet is clogged.
Outlet hose is clogged or
Water is not being
kinked.
pumped.
The lint trap is clogged.
Water is draining
even though the
Outlet hose is too low.
appliance is not
pumping.
Inlet or outlet hose is not
Water is running
screwed on tightly enough.
out (appliance is
"leaking").
Lint trap not closed properly.
Wash result is not satisfactory
Possible causes
Malfunction
Possible causes
Solutions, tips
Use colour freshener if necessary
(available at chemist's). In future, use
detergent without bleaching agent.
Solutions, tips
Plug it into the socket properly.
Check fuse; switch on if necessary.
Replace fuse.
Select the desired wash cycle using the
cycle selector (2).
Properly close the loading door (must
hear it "snap" shut).
Press the (6) button.
The program cycle starts as soon as the
appliance has determined the amount of
laundry.
Open valve.
Close loading door properly.
Check water inlet hose; dismantle if
necessary and re-align.
Clean the filter on the water inlet hose
(see page EN-31).
Clean the filter on the inlet (see
page EN-31).
Check outlet hose; dismantle if
necessary and re-align.
Clean lint trap (see page EN-32).
Place outlet hose higher.
Screw down inlet or outlet hose down
tighter.
Properly close the lint trap (see
page EN-32).