Cycle End; Additional Functions - Hanseatic HWM6T214D User Manual

Page EN-16 Washing

Cycle end

The appliance stops automatically as soon as
the selected cycle is finished. "End" will now
be shown in the display (3).
1. Turn the cycle selector (2) to "Off".
2. Once the locking time has completed
after approx. 2 minutes and you hear a
click releasing the door (13), you can then
remove the laundry.
3. Leave the appliance door (13) open be-
tween wash cycles and pull the dispens-
ing drawer (1) out slightly to allow the
inside of the appliance to dry.
4. Turn off the valve and take the mains plug
out of the wall socket.
If no further settings are made, the appliance
will automatically switch off after 15 minutes.
The spin speed affects the noise
emissions of the appliance and the
residual dampness of the laundry.
The higher the spin speed, the
higher the noise emissions and the lower
the residual dampness.

Additional functions

Start time preselection
The cycle usually starts as soon as you have
pressed the "Start/Pause" button (9).
The appliance, however, offers you the option
to delay the start time. The delay can be set
in one-hour increments. The maximum delay
time is 23 hours.
1. Select the desired cycle using the cycle
selector (2).
2. Press the button "Start time pre-selec-
tion" (6).
"1h" is shown in the display (3), i.e. the se-
lected cycle will start in one hour.
3. Press the "Start time preselection" button (6)
repeatedly until the desired delay time is set.
4. Press the "Start/Pause" button (9).
The cycle will start after the delay setting
has elapsed.
Terminate delay
If you have already pressed the "Start/Pause"
button (9):
• Press the button "Start time pre-selec-
tion" (6).
The cycle will now start.
If you have not already pressed the "Start/
Pause" button (9):
• Press the "Start time preselection" but-
ton (6) repeatedly until the delay time is
no longer shown in the display (3).
Button lock
The button lock allows you to secure the ap-
pliance from unwanted use of the buttons.
You can activate the button lock only if you
have previously selected a cycle.
Activating button lock
(2) (3)
Aus
Extrakurz 15' Baumwolle
60°C
Anzeige
Kurz 60' Baumwolle 40°C 4
Jeans/
Baumwolle
Dunkle Kleidung
Mix Eco 20°C
Sport Pflegeleicht
Hand-/
Wolle
Feinwäsche
Schleudern/Abpumpen / / Spülen
Allergie
• Simultaneously hold both "Prewash" (7)
and "Auto-crease" (8) buttons until the
"CL" symbol appears in the display (3).
Now if any button is pressed or the cycle
selector (2) is turned, it will have no effect.
"CL" flashes in the display (3).
Deactivating button lock
• Simultaneously hold both "Prewash" (7)
and "Anti-crease" (8) buttons until "CL"
appears and flashes in the display (3).
If "CL" disappears after a few seconds, the
button has been deactivated again.
(7) (8)
Funktionen
Schleudern Startzeit- Start/
Temp. vorwahl Vorwäsche Knitterschutz
Pause