Hanseatic HWMK814B User Manual page 85

You can fit the outlet hose in two ways:
– Attaching with hose holder over the edge
of a bathtub or washbasin
– Attaching the discharge manifold to a
washbasin.
Attaching with a hose holder
• Put the end of the water outlet hose (17)
over a hose holder and hang it over the
edge of a bath or a washbasin. You can
find a hose holder in a specialist shop or
DIY store.
Attaching the discharge manifold to a
washbasin
• The water outlet hose (17) is mounted
onto a special device, which can be found
on the outlet manifold of a washbasin. In
doing so the lock on the siphon must be
removed.
Have this fixed by a specialist!
There is a washer in an unused connec-
tion manifold to ensure that no water
can run out. This washer must be replaced by
a seal ring before connecting the water outlet
hose.
Installation, connection and initial commissioning
Establish the water supply
Risk of damage to property!
Improper handling of the appliance
may result in damage.
■ Only use the hose set delivered with
For the water supply, you will need a valve
with a 3/4 inch screw connection.
1. Screw the enclosed water inlet hose onto
NOTICE
the appliance to connect to the water
supply. Do not use old hoses.
ATTENTION: Do not connect to the
hot water supply.
Only connect the appliance to a wa-
ter supply with an inlet water pressure
between 0.05 MPa and 1.0 MPa (0.5
to 10.0 bar). For higher water pres-
sure, a pressure regulator needs to
be arranged. Enquire about the water
pressure with the water authority.
Do not use a pipe wrench to screw
down the union nuts on the valve.
This can damage the union nuts.
the connection (16) by hand. To do so,
turn the union nut (25) clockwise.
Page EN-37
(16)
(25)