Cycle End; Additional Functions - Hanseatic HWM6T214A2 User Manual

Cycle end

The appliance stops automatically as soon as
the selected cycle is finished. 'End' will now
be shown in the display (3).
1. Turn the cycle selector (2) to Off.
2. Once the locking time has completed af-
ter approx. 2 minutes and you hear a click
releasing the door, you can then remove
the laundry.
3. Leave the loading door open and pull the
dispensing drawer (1) out slightly to allow
the inside of the appliance to dry.
4. Turn off the tap and take the mains plug
out of the wall socket.

Additional functions

Start time preselection
The cycle usually starts as soon as you have
pressed the Start/Pause button (9).
The appliance, however, offers you the option
to delay the start time. The delay can be set
in one-hour increments. The maximum delay
time is 23 hours.
1. Select the desired cycle using the cycle
selector (2).
2. Press the Start time preselection button (6).
A '1h' is shown in the display (3), meaning
that the selected cycle will start in one hour.
3. Press the Start time preselection but-
ton (6) repeatedly until the desired delay
time is set.
4. Press the Start/Pause button (9).
The cycle will start after the delay setting
has elapsed.
Washing process
Terminate delay
If you have already pressed the Start/Pause
button (9):
• Press the Start time preselection button (6).
The cycle will now start.
If you haven't already pressed the Start/
Pause button (9) :
• Press the Start time preselection but-
ton (6) repeatedly until no delay is shown
in the display (3).
Safety lock (child safety lock)
The safety lock allows you to secure the ap-
pliance from unwanted use of the buttons.
You can activate the safety lock only if you
have previously selected a cycle.
Activating the safety lock
(2) (3)
Aus
Extrakurz 15' Baumwolle 60°C
Anzeige
Kurz 60' Baumwolle
4 40°C
Jeans/
Baumwolle
Dunkle Kleidung
Eco 20°C
Mix
Sport Pflegeleicht
Hand-/
Wolle
Feinwäsche
Schleudern/Abpumpen / / Spülen
Allergie
• Press and hold both the Prewash button
(7) and Anti-crease button (8) until 'CL' is
shown in the display (3).
Now if any button is pressed or the cycle
selector (2) is turned, it will have no effect.
The displays (3) shows only a flashing 'CL'.
Deactivating the safety lock
• Press and hold both the Prewash button
(7) and Anti-crease button (8) until a flash-
ing 'CL' is shown in the display (3).
Once the 'CL' display disappears after a
few seconds, the safety lock is again de-
activated.
Page EN-15
(7) (8)
Funktionen
Schleudern Startzeit- Start/
Temp. vorwahl Vorwäsche Knitterschutz
Pause