F&F LE-01MR v2 User Manual page 12

domestic and industrial automation
• after passing the PIN verification, the first of the available configuration parameters - Id address
of the meter in the RS-485 network - is displayed;
• the transition between the parameters is made by short pressing the button, long pressing takes
you to the edition of the selected parameter;
• the parameter is set by short presses of the button, a long press of the button confirms the new
value.
No. Configuration parameters
1 Meter address in the RS-485 net-
work
2 Baud rate
3 Parity
4 Number of stop bits
5 Resetting the auxiliary active en-
ergy meter
6 Resetting the auxiliary reactive en-
ergy meter
7 Resetting the maximum active
power demand indicator
LE-01MR v.2 – User manual v.1.0.0
Value
1 (default) – 247
6 – 9600 bps (default)
7 – 19200 bps
8 – 38400 bps
9 – 57600 bps
10 – 76800 bps
11 – 115200 bps
0 – None (default)
1 – Odd
2 – Even
Stop 1 – 1 (default)
Stop 2 – 2
The display cyclically shows the reset text and the current
value of the auxiliary meter. Press and hold down the button
on the front of the meter to reset the indication.
The display cyclically shows the reset text and the current
value of the auxiliary meter. Press and hold down the button
on the front of the meter to reset the indication.
The registered value of the maximum active power demand
appears on the display as
Press and hold down the button on the front of the meter to
reset the indication.
P xxxxxx +
12