Fpga Com Port Uart Mux - Advantech MIC-6311 User Manual

Response:
39 28 00 <setting>
Change LAN channel selection priority:
ipmitool raw 0x2e 0x40 0x39 0x28 0x00 0x04 0x01 <setting>
Response:
39 28 00
3.5.5

FPGA COM Port UART MUX

MIC-6311 implements several serial interfaces, which can be configured in multiple
ways. This is done by implementing an UART MUX (refer to Chapter– UART and
UART Multiplexer-). The BMC provides OEM commands to configure these UARTs
via IPMI. Following COM1 / COM2 port settings are available:
Caution! (Caution: Verify note below about the UART dependency!):
COM interfaces:
Table 3.8: OEM Interfaces
Port
0x00
0x01
COM1 MUX:
Table 3.9: COM1 UART MUX Settings
Setting
0x00
0x01
0x02
0x03
COM2 MUX:
Table 3.10: COM2 UART MUX Settings
Setting
0x00
0x01
0x02
0x03
Interface
COM1
COM2
Connection
no interface connected, open
Serial-over-LAN (SOL)
Front panel Micro-USB (default)
AMC connector port 15
Connection
no interface connected, open
Serial-over-LAN (SOL) (default)
Front panel Micro-USB
AMC connector port 15
49 MIC-6311 User Manual