Jumpers And Switches; Clear Cmos (Cn2) - Advantech MIC-6311 User Manual

SRIO bridge
PCI bridge
Thermal
Sensor
PCH
FPGA
CN2
SW3
1.5

Jumpers and Switches

Table 1.4 and Table 1.5 list the jumper and switch functions. Read this section care-
fully before changing the jumper and switch settings on your MIC-6311 board.
Table 1.3: MIC-6311 Jumper Descriptions
Number
CN2
JP1
Table 1.4: MIC-6311 Switch Descriptions
Number
FPGA_SW1
FPGA_SW2
UART_SW
SW3
1.5.1

Clear CMOS (CN2)

This jumper is used to erase CMOS data. Follow the procedures below to clear the
CMOS.
1. Turn off the system.
2. Close jumper CN2 for approximately 3 seconds.
3. Set jumper CN2 as Normal.
4. Turn on the system. The BIOS is reset to the default setting.
MIC-6311 User Manual
FPGA_SW1
PCIE bridge JP1 FPGA_SW2
Figure 1.2 Board map
Function
Clear CMOS
PMC VIO
Function
These two switches are for PCIE NT setting LAN configuration
RIO COM RS232/RS485/ RS422 mode selection
Front COM & RTM COM1/COM2 ports selection for SIO UART
8
UART_SW
I350
Thermal
Sensor
CPU
Onboard memory
Thermal
Sensor