DFI 661FX-MLV User Manual page 69

SIS 10/100M Ethernet
This field is used to enable or disable the onboard LAN.
SIS MAC Address Input
Move the cursor to this field and press <Enter>, then enter the
MAC address. This field is configurable only if the "SIS 10/100M
Ethernet" field is set to Enabled.
SIS Serial ATA Controller (661FX-MLV only)
This field is used to enable or disable the onboard SATA.
SIS Serial ATA Mode (661FX-MLV only)
IDE Sets the SATA devices as ordinary IDE devices.
RAID Sets the SATA devices for RAID. Configure RAID in
the SIS RAID BIOS Setting Utility.
3.1.4.3 IDE HDD Block Mode
Enabled The IDE HDD uses the block mode. The system
BIOS will check the hard disk drive for the maximum
block size the system can transfer. The block size will
depend on the type of hard disk drive.
Disabled The IDE HDD uses the standard mode.
3.1.4.4 Onboard LAN Boot ROM
Enable this field if you wish to use the boot ROM (instead of a
disk drive) to boot-up the system and access the local area net-
work directly.
If you wish to change the boot ROM's settings, type the <Shift>
and <F10> keys simultaneously when prompted during boot-up.
Take note: you will be able to access the boot ROM's program
(by typing <Shift> + <F10>) only when this field is enabled.
3.1.4.5 Onboard FDC Controller
Enabled Enables the onboard floppy disk controller.
Disabled Disables the onboard floppy disk controller.
BIOS Setup
3
69