DFI 661FX-MLV User Manual page 35

•
Line-out Jack (Lime)
This jack is used to connect external speakers for audio output
from the system board. Using this jack disables the front au-
dio's line-out function.
Front Audio
The front audio connector (J1) allows you to connect to the
line-out and mic-in jacks that are at the front panel of your sys-
tem. Using this connector will disable the rear audio's line-out
and mic-in functions.
Remove the jumper caps from pins 5-6 and pins 9-10 of J1 prior
to connecting the front audio cable connector. Make sure pin 1
of the cable connector is aligned with pin 1 of J1. If you are not
using this connector, make sure to replace the jumper caps back
to their original pin locations.
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
6-Channel Audio
The audio jacks at the rear panel will support 6-channel audio
only when the audio utility is configured to support this function.
Mic-in at the rear I/O panel will be disabled. Use the front audio's
mic-in jack.
Driver Installation
Install the "Realtek Audio Drivers". An audio software application
program will at the same time be installed into your system. This
program will allow you to configure 2-channel, 4-channel and 6-
channel audio modes as well as configure the audio effects. Refer
to chapter 4 for more information.
Hardware Installation
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
2
35