Table of Contents
Advertisement
2
Hardware Installation
Adding a Second IDE Disk Drive
When using two IDE drives, one must be set as the master and
the other as the slave. Follow the instructions provided by the
drive manufacturer for setting the jumpers and/or switches on
the drives.
The system board suppor ts Enhanced IDE or ATA-2, ATA/33,
ATA/66, ATA/100 or ATA/133 hard drives. We recommend that
you use hard drives from the same manufacturer. In a few cases,
drives from two different manufacturers will not function prop-
erly when used together. The problem lies in the hard drives, not
the system board.
BIOS Setting
Configure the onboard primary or secondary IDE in the Inte-
grated Peripherals submenu ("SIS OnChip IDE Device" field) of
the BIOS. Refer to chapter 3 for more information.
42
Note:
Refer to your disk drive user's manual for information about
selecting proper drive switch settings.
Important:
If you encountered problems while using an ATAPI CD-ROM
drive that is set in Master mode, please set the CD-ROM drive
to Slave mode. Some ATAPI CD-ROMs may not be recognized
and cannot be used if incorrectly set in Master mode.
Advertisement
Table of Contents
