DFI 661FX-MLV User Manual page 39

2.6.4 SATA Connectors (661FX-MLV only)
The 661FX-MLV system board is equipped with 2 SATA connec-
tors at locations J11 (SATA 2) and J12 (SATA 1) for connecting
SATA devices. Connect one end of the SATA cable to a SATA
connector and the other end to your SATA device.
Configure these connectors in the Integrated Peripherals
submenu ("SIS OnChip PCI Device" section) of the BIOS. Refer
to chapter 3 for more information.
Configuring RAID on SATA Drives
The SiS 964 south bridge controller allows configuring RAID on
the SATA drives. It supports RAID 0, RAID 1 and JBOD. The fol-
lowing must be set accordingly.
• BIOS Setting
1. Set the "SiS Serial ATA Controller" field to "Enabled". (In-
tegrated Peripherals submenu - "SIS OnChip PCI Device"
section of the Award BIOS.)
2. Set the "SiS Serial ATA Mode" field to "RAID". (Integrated
Peripherals submenu - "SIS OnChip PCI Device" section of
the Award BIOS.)
3. Set the "RAID or SCSI Card Boot" field to "SiS 964
RAID". (Advanced BIOS Features submenu of the Award
BIOS.)
Hardware Installation
1
SATA 2
SATA 1
2
7
39