Table of Contents
Advertisement
e. Do not attach a saw chain woodcarving blade or toothed saw
blade. Such blades create frequent kickback and loss of control.
1.4 Additional safety instructions for the scouring machine
Do not use the tool near explosive materials.
Do not work with materials containing asbestos.
Prior to every use, check the tool and its cable and plug. Have damages repaired only
by specialists.
Insert the plug into the socket only when the tool is switched off.
Plug and switch the machine off if it is not under supervision, in case of putting up and
stripping down the machine, in case of voltage drop or when fixing or mounting an
accessory.
Switch the machine off if it stops for whatever reason. Like that you avoid that it starts
suddenly.
Check the milling head before every use. Do not use damaged or sluggishly running
milling stars.
Make sure that the tool was mounted properly, and let it run idly in a safe position for
30 seconds. Stop the tool immediately if you found considerable vibrations or other
defects.
Don't use the machine if a part of the housing is damaged or in case of damages on
the switch, the cable or plug.
Electrical tools have to be inspected visually by a specialist in regular intervals.
After interruption of your work, restart the tool only after having made sure that the
milling head and the milling stars are moving freely.
Do not touch rotating parts.
Persons under 16 years are not supposed to use the tool.
Keep the handles dry, clean and free of oil and grease.
Caution! The milling head still runs for a little while after the machine is switched off.
When working with the machine, wear ear protectors, dust mask, goggles, safety
gloves and sturdy work clothes.
Always hold the machine with both hands.
Make sure that persons in the work space are not endangered by particles flying
around.
In order to avoid the star holder and the milling stars getting damaged, work very
carefully on edges or corners.
Do not work on surfaces with steel reinforcements which lie open.
If the mains cable gets damaged or cut during the use, do not touch it. Switch off the
tool and then pull the plug out of the socket by using and extreme precaution. Never
use the tool with a damaged mains cable.
7
Advertisement
Table of Contents
