Configuring The E-Mail Smtp Settings - Lexmark CX737 User Manual

Set up, install, and configure
1
Connect one end of the telephone cable to the line port of the printer.
2
Connect the other end of the cable to the RJ‑11 adapter, and then connect the adapter to the wall jack.
3
If you want to connect another device with a non‑RJ‑11 connector to the same wall jack, then connect it
directly to the telephone adapter.
Connecting to a distinctive ring service
A distinctive ring service lets you have multiple telephone numbers on one telephone line. Each telephone
number is assigned a different ring pattern.
Note: These instructions apply only to printers that support analog fax. For more information, see
fax" on page 33.
1
From the home screen, touch Settings > Fax > Fax Setup > Fax Receive Settings > Admin Controls >
Answer On.
2
Select a ring pattern.
Setting the fax date and time
Note: Make sure that fax is configured. For more information, see the
1
From the home screen, touch Settings > Device > Preferences > Date and Time > Configure.
2
Configure the settings.
Configuring daylight saving time
Note: Make sure that fax is configured. For more information, see the
1
From the home screen, touch Settings > Device > Preferences > Date and Time > Configure.
2
In the Time Zone menu, touch (UTC+user) Custom.
3
Touch UTC (GMT) Offset, and then configure the settings.
Configuring the fax speaker settings
Note: Make sure that fax is configured. For more information, see the
1
From the home screen, touch Settings > Fax > Fax Setup > Speaker Settings.
2
Do the following:
•
Set Speaker Mode to Always On.
•
Set Speaker Volume to High.
•
Enable Ringer Volume.
Configuring the e‑mail SMTP settings
Configure the Simple Mail Transfer Protocol (SMTP) settings to send a scanned document through e-mail. The
settings vary with each e‑mail service provider.
Setting up the printer to fax
Setting up the printer to fax
Setting up the printer to fax
40
"Supported
section.
section.
section.