Advertisement
sure to enter a specified string or ASCII codes to search for in the Buffer Edit
dialog box.
•
The string for search is blank. Input it in Search dialog: Enter a string in the
Buffer Edit dialog box. Then you can use The first time search, Continue to
search, or Search Next functions.
•
Search pattern not found!: The system did not find a matched string or
ASCII code.
•
User chip is MfgID = 0089, DeviID = 0051: This display on the Operation
Information window indicates that the chip's ID detection function detected a
different ID than specified in the manual.
•
ID check error. Ignore: You can ignore the detected ID error and continue the
operation.
•
ID check error: The operation stops because of the ID check error. If you have
good knowledge of this chip, you may ignore the ID error and continue the
operation. Exercise caution to avoid damaging the chip.
•
Pin check error. Ignore: The system indicates an error during the pin check.
Ignore it and continue.
•
Pin check error: An error occurred during the pin check, and the operation
ceased.
•
Programmer not found: The programmer is not connected to the PC or it is
connected improperly. Check the connection.
•
Programmer not ready: Turn off the programmer power switch and turn it
on again after a few seconds.
•
Programmer is running: The programmer hardware is operating. Wait until
the operation is finished.
•
File open error: The open file operation failed.
•
Out of Memory: The memory overflows.
•
Production mode isn't available for this chip: Since the production mode is
dependent on the pin check, the chips without pin check function are not
applicable for production mode.
Advertisement
