Select Load from the File menu to open the Load File dialog box, as illustrated
below. The red labels refer to the numbered notations follow this figure.
1. Buffer. To select the Buffer name from the drop down list. The system loads
the file data into the buffer accordingly.
2. File Name. To enter the name of the data file to load it, or you can select
Browse and choose the file using the Select File box .
3. File Type. To select the type of the file from a drop down list. Different file
types are included here, e.g. Binary, Intel Hex, Motorola S record, JEDEC,
POF, TI, etc.
4. File Mode. To select one of the following File Modes from the drop down list:
•
Normal to load the whole file
•
Even to load the first byte and discard the second byte out of every
two bytes
•
Odd to discard the first byte and load the second byte out of every
two bytes
•
1st byte of 4 to load first byte and discard the other three bytes out of
every four bytes