Advertisement
If an adapter is required for programming, the system displays information
about the adapter in the device information screen.
3.2.4
Execute programming
Insert the chip properly into the socket. If the prompt information indicates a need
for an adaptor, you may purchase the adapter. The operation procedure for the
programming of a chip is described as the following steps:
Blank Check
NOTE: You can skip this step if the chip is brand new.
The Blank Check fails on electrically erasable chips containing some
information. In this case, perform the Erase operation first. You do not
need to erase EPROM chips for which the data can be overwritten.
Program
Verify
NOTE: This step is necessary. The chip must pass Verification before the
programming can be implemented. Some chips provide only the
accumulation check function, such as VerifyCRC instead of a unit-to-unit
check function. Very few chips do not provide the accumulation check
function.
Security or Protect if encryption is required
NOTE: You may need to set the configuration word before performing
encryption. Refer to Device Configuration Word on page 37 for more
information. Select Auto to finish all the operations in one step.
Execute Production Mode to Program Chips in Batches
Select Production Mode from the Option menu to program devices in large
quantities. This function facilitates the job of the user who programs chips in
batches. In order to program chips in batches, the programmer always conducts the
insertion test. The programmer waits for the chip insertion to initiate while the
system displays the following prompt: Please, insert a device into the socket. Once
you have properly inserted the chip, the auto batch-processing command starts
automatically.
Advertisement
