Robe iSpiider User Manual page 44

Yoke cover
Screws* must be tightened
in the order 1-->8.
* Tighten all screws in two steps:
Step 1 - use tightening torque 0.5 Nm (pre-tightening)
Step 2- use tightening torque 2.5-3 Nm (final tightening)
Carefully check the gasket for signs of deformities or damages and if it is correctly placed before screwing
the yoke cover back. The gasket is part of chassis.
Do not forget to connect grounding wire between chassis and yoke cover.
8 x hex socket head screw M4x8
Tightening torque: 2.5-3 Nm
44