Operating Determination - Robe iSpiider User Manual

2. Operating determination

WARNING! This unit does not contain an ON/OFF switch. Always disconnect the power input cable
from mains to completely remove power from unit when not in use or before cleaning or servicing the unit.
Avoid brute force when installing or operating the device.
Never lift the fixture by holding it at the fixture head as the mechanics may be damaged. Always hold the fixture
at the transport handles.
When choosing the installation spot, please make sure that the device is not exposed to extreme heat or dust.
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the fixture.
Always secure the fixture with an appropriate safety wire.
Only operate the fixture after having checked that the housing is firmly closed and all screws are tightly fastened.
Do not block the front cover glass with any object when the fixture is under operation.
The fixture becomes very hot during operation. Allow the fixture to cool approximately 20 minutes prior to ma-
nipulate with it.
To avoid damage of an internal optical system of the fixture, never let the sunlight (or
other light source) lights directly to the lens array, even when the fixture is not working
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device.
The fixture housing never must be covered with cloth or other materials during its operation. Do not block fans
or fans ventilation slots with any object. Fans and ventilation slots must remain clean.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Potential foggy front lens array does not influence function of the fixture and does not
subject to complaint.
Please use only an original ROBE packaging (paper box, loader case or foam shell) for
transporting the device, otherwise potential damage of the device during its transport
will not subject to warranty.
The fixture must not come into contact with sea water (salt water).
Damages or corrosion issues resulting from salt water will void
the manufactures warranty and will not be subject to any warranty
claims or repairs.
The product (covers and cables) must not be exposed to a high frequency electromagnetic field higher than 3V/m.
Immunity of the equipment is designed according to the standard EN 55035 Electromagnetic compatibility of
multimedia equipment - Immunity requirements
Emission of the equipment complies with the standard EN55032 Electromagnetic compatibility of multimedia
equipment – Emission Requirements according to class B.
Contains FCC ID: 2A6PL-DMXRDMRW001
Contains IC: 29573-DMXRDMRW001
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
4