Fcc Information; Specifications; Listings And Approvals - DMP Electronics Security Command 690 Installation Manual

FCC Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications made by the user and not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

Specifications

Operating Voltage 12 VDC Nominal
Current Draw
690/690F
Standby 77mA
Alarm 84mA
790/790F
Standby 77mA + 1.6mA per active zone
Alarm 84mA + 2mA per active zone
693/793
Standby 92mA +1.6mA per active zone
Alarm 120mA +2mA per active zone
Dimensions 6.5" W x 5" H x 1" D

Listings and Approvals

Underwriters Laboratories (UL) Listed
UL 365 Police Connected Burglar
UL 609 Local Burglar
UL 1023 Household Burglar
UL 1076 Proprietary Burglar
UL 1610 Central Station Burglar
UL 1635 Digital Burglar
UL 985 Household Fire Warning
UL 864 Fire Protective Signaling
California State Fire Marshal (CSFM)
FCC Part 15
FCC Part 68 RFID Reader FCC ID:CCK793
800-641-4282
www.dmp.com
Made in the USA
Panel Compatibility
DMP Command Processor™ panels
XR500 Series, XR2500F, XRSuper6, XR20, XR40, XR200,
XR200-485
Accessories
Backboxes
695 or 696 4" square mounting box
777 protective keypad cover
Keypad Wiring Harness
300 4-wire harness
300-5 5-wire harness
300-12 12-wire harness
300-512 12-wire harness, 5 ft. long
Proximity Readers for 793 keypads
PP-6005B ProxPoint® Plus
MP-5365 MiniProx™
PR-5455 ProxPro II®
MX-5375 MaxiProx®
TL-5395 Thinline II®
Proximity Credentials for 693/793 keypads
1306P Prox Patch™
1306PW Prox Patch™ 26-Bit
1326 HID ProxCard II® Card
1346 HID ProxKey II® Access Device
1386 HID ISOProx II® Card
INT RUSI ON • FIRE • AC C ESS • NETWO RKS
2500 North Partnership Boulevard
Springfield, Missouri 65803-8877
30mA Standby 75mA Peak
20mA Standby 110mA Peak
25mA Standby 125mA Peak
200mA Standby 700mA Peak
20mA Standby 115mA Peak