Load Material - Pitney Bowes AddressRight DA700 Operating Manual

3 Features and adjustments
®
AddressRight Printer DA700/DA750
Setting Up A
Job
(continued)
Page 3-16

6. Load Material

Once your printer is set up, you can load material and
make a test print.
To avoid misfeeds, follow these instructions:
l. Make sure the input area is free of dust and other
matter.
2. Take a manageable amount of material and while
holding it as shown, fan all sides of the material to
separate each piece. This step helps keep
misfeeds to a minimum.
3. Tamp the material on a flat surface, making sure
that the stack is square.
4. Shingle the stack as you load it into the input
area. Load envelopes so the side to be printed
faces up. Flaps should be down and oriented
away from the feed roller (flaps trailing).
Position the right edge of the envelopes flush
against the rear wall.
Begin with just a few envelopes to start the stack
and get the proper contour, then add several
more pieces. Then add the remainder of the
stack.
5. Adjust the position of the media thickness knob
as described on the next page.
SV61027C · Rev A
Operating Guide