Connect The Parallel Cable Or Serial Cable - Pitney Bowes AddressRight DA700 Operating Manual

2 Getting started with the DA700/DA750 printer
®
AddressRight Printer DA700/DA750
Connecting
the DA700/
DA750 to
Your
Computer
Connecting the Parallel Cable or Serial Cable
Use the parallel cable supplied to connect the DA700/
DA750 to your computer, or use an approved serial
cable. Each end of the parallel cable has a connector.
One end is labeled "Printer" and the other is labeled
"Computer."
1. To connect the Parallel Cable (supplied) to the printer,
align the end of the cable connector labeled "Printer"
with the parallel port located on the right side of the
printer's interface panel, and push the cable connec-
tor into the port. The interface panel is located at the
rear of the printer. It contains the main power switch,
the parallel cable port, the serial port, the power
receptacle and fuse.
Parallel Port
2. Secure the connector by snapping the two wire clips
over the corresponding tabs on the connector.
SV61027C · Rev A
Operating Guide
Serial Port
Page 2-9