Assembling The Da700/Da750; Attach The Wire Frame; Install The Sliding Fence; Position The Output Stacker - Pitney Bowes AddressRight DA700 Operating Manual

2 Getting started with the DA700/DA750 printer
®
AddressRight Printer DA700/DA750
Important
Safety Notes
(continued)
Assembling
the DA700/
DA750
• DO NOT remove covers. The machine covers serve
to enclose hazardous parts. If the machine has been
dropped or has otherwise had the covers stressed in
any way, report it to your Pitney Bowes Customer
Service Representative.
• To reduce the risk of fire and/or electrical shock, do
not attempt to disassemble this machine. If service is
required, contact your Pitney Bowes Customer
Service Representative.
• Keep fingers, loose clothing, jewelry and long hair
away from the moving parts.
• Use only Pitney Bowes approved ink cartridges and
cleaners. Read all instructions before attempting to
operate the equipment.
• Follow any specific occupational safety and health
standards for your workplace or area.
Once you've placed the printer in a suitable location,
assemble the printer components in the following order:
NOTE: Do not plug the printer into the power source
until you've completed steps 1-4.
1. Attach the wire frame input stacker (page 2-6).
2. Install the sliding fence (page 2-7).
3. Position the output stacker (page 2-8).
4. Connect the parallel or serial cable (page 2-9).
5. Attach the power cord and turn the printer ON
(page 2-11).
6. Install the ink jet cartridges (page 2-12).
SV61027C · Rev A
Operating Guide
Page 2-5