Table of Contents
Advertisement
2)
Press the <ENTER> button.
f The [DIGITAL LINK] screen is displayed.
3)
Press as to select [EXTRON XTP].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f For details of the "XTP transmitter", visit the following website of Extron Electronics.
https://www.extron.com/
[WIRED LAN]
Perform the connection settings to use wired LAN.
1)
Press as to select [WIRED LAN].
2)
Press the <ENTER> button.
f The [WIRED LAN] screen is displayed.
3)
Press as to select [IP VERSION].
4)
Press the <ENTER> button.
f The [IP VERSION] screen is displayed.
5)
Press as to select an item, and press the <ENTER> button.
[IPv4]
[IPv6]
[IPv4 & IPv6]
6)
Press the <MENU> button.
f The [WIRED LAN] screen is displayed.
f Proceed to Step 12) when [IPv6] is selected.
7)
Press as to select [IPv4 SETTINGS], and and press the <ENTER> button.
f The [IPv4 SETTINGS] screen is displayed.
8)
Press as to select an item, and change the setting according to the operation instructions of the
menu.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
9)
Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen is displayed.
10) Press qw to select [OK], and press the <ENTER> button.
f Setting for the IPv4 address is saved.
11) Press the <MENU> button.
f The [WIRED LAN] screen is displayed.
166 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
Select this item when connecting the optional DIGITAL LINK output supported device (Model No.:
ET-YFB100G, ET-YFB200G) to the <DIGITAL LINK> terminal.
Select this item when connecting the "XTP transmitter" of Extron Electronics to the <DIGITAL LINK>
terminal.
Uses only the "IPv4" protocol.
Uses only the "IPv6" protocol.
Both the "IPv4" and the "IPv6" protocols can be used.
[ON]
[OFF]
Enter the IP address.
Enter the subnet mask.
Enter the default gateway address.
Select this item when using the DHCP server that exists in the
network to which the projector is to be connected. IPv4 address is
automatically acquired.
Select this item when setting the IPv4 address manually.
Set [IP ADDRESS], [SUBNET MASK], and [DEFAULT GATEWAY].
Advertisement
Table of Contents
