Johnson Controls Qolsys IQ Remote PowerG Installation Manual page 11

INSTALLING THE IQ REMOTE PG
ENROLLING THE IQ REMOTE PG
POWERG ENROLLMENT:
1. On primary panel, Start AutoLearn process as indicated in the primary
panel manual. For manual installation, enter the Device ID 380-XXXX.
2. On the IQ Remote PG enrollment page, select "PowerG pair".
3. The IQ Remote PowerG will be recognized by the primary panel.
Configure options accordingly.
4. The IQ Remote PowerG will move to the home page.
WI-FI ENROLLMENT:
1. Enable Wi-Fi on the IQ Remote PowerG (same Wi-Fi network as the
primary panel).
2. From primary panel, start process for pairing IQ Remote using Wi-Fi.
3. Press "Wi-Fi Pair" on IQ Remote PowerG enrollment page.
4. The remote will connect and start looking for software updates (if a
new software exists, it will download and install it then go to home
page).
Note: Automatic software update upon enrollment occurs when
enrolling through Wi-Fi only.
Disclaimer: PowerG enrollment shall be used with UL/ULC installation.
Wi-Fi enrollment is not UL/ULC certified
QOLSYS CONFIDENTIAL AND PROPRIETARY
PAGE OF 11 42