Table of Contents
Advertisement
U3025AE10
Figure 46
Calibration, Cal Set Viewer
9. From the Cal Sets drop-down menu, select 999.x (the next sequential number). Select
the Reflection Tracking(1,1) term in the center drop-down menu and ensure that the
Enable and Error Terms are selected as shown in
NOTE
You may also create a table on the PNA and enter the limit line stimulus and
response values. Select Limit Test ON and Limit Line ON, and press Show
Table. See
Figure 47
Limit Values for Reflection Tracking Trace (Port 1-12)
User's Guide
Figure
47.
Figure
47.
Error Terms
Operational Check
Enable
49
Advertisement
Table of Contents
