Agilent Technologies U3025AE10 User Manual page 45

U3025AE10
NOTE All DUT control lines must be set with each command sent. Logic 0 = high
Figure 38 DUT Control Line Pin Assignment
Table 10 DUT Control Line Pin Assignment
Pin Signal Name
Number
1 Line 1
2 Line 2
3 Line 3
4 Line 4
5 Line 5
6 Line 6
7 Line 7
8 Line 8
9
10
11
12 +2 V to +5 V
13 Positive Input
14 Negative Input
15 Gnd
User's Guide
Description
Output port of line 1
Output port of line 2
Output port of line 3
Output port of line 4
Output port of line 5
Output port of line 6
Output port of line 7
Output port of line 8
Not used
Not used
Not used
The voltage input to pin 13. (The voltage can be varied by
rotating the voltage adjustment trimmer on the front panel).
Input a signal that is outputted when each line is high from
pin 12 or external dc power supply.
Input a signal that is outputted when each line is low from
the external dc power supply. Able to output 0 V as low from
the each line by connecting to pin 15.
ground terminal
DUT Control Lines
39