Table of Contents
Advertisement
2.2.2 Installation Instructions
As shown in Figure 2.4, the 6 screws at "2" are used to fix the turret bracket on the turret; the 6 screws at "1" are used to fix
the radar main unit to the turret bracket; the screws at "3" are used for The turntable is fixed to the whole machine bracket.
Note:
1)
Please prepare a set of hex driver (see Fig.5);
2)
It is recommended to install more than two people;
3)
In order to improve the angle measurement accuracy, please adjust the bottom level of the turntable before
installation.
2.3 Precautions
1)
Please keep a certain distance from the radar to prevent personal injury caused by sudden rotation of the radar;
2)
Be sure to ensure the level of radar installation;
Figure 2.4 Screw mounting position diagram
Figure 2.5 Hex wrench
9
Tel: 886.909 602 109 Email: sales@salukitec.com
www.salukitec.com
Advertisement
Table of Contents
