Table of Contents
Advertisement
2)
Install "WinPcap_4_1_3.exe";
3)
Run "anti_uav_radar.exe";
3.4 Operating Steps
1)
Open "anti_uav_radar.exe", and the "Network Port Selection" window will pop up, select the network port (usually
Ethernet port) connected to the radar;
2)
If the radar is working properly, select "System Control / Antenna Power-on Mode" on the main interface as
"Transceiver and Power-on". Click the "Work" button and the radar will start working normally.
Figure 3.1 Network port selection interface
12
Tel: 886.909 602 109 Email: sales@salukitec.com
www.salukitec.com
Advertisement
Table of Contents
