Scanner-Bioptic ACK/NAK Mode
Bioptic ACK/Nak On must be scanned so the scanner will wait for an ACK or NAK
from a bioptic scanner after each packet is sent. The Scanner-Bioptic ACK/NAK
Timeout (below) controls how long the scanner will wait for a response. Default =
Bioptic ACK/NAK Off.
Scanner-Bioptic ACK/NAK Timeout
This allows you to set the length (in milliseconds) for a timeout for a bioptic
scanner's ACK/NAK response. Scan the barcode below, then set the timeout (from
1-30,000 milliseconds) by scanning digits from the
scanning Save. Default = 5100.
HF680 Series User Guide
* Bioptic ACK/NAK Off
Programming
ACK/NAK Timeout
Bioptic ACK/NAK On
Chart, then
27