Connection Pane; Sensor Controls Pane - Banner ZMX Series Instruction Manual

X(mm)
Horizontal distance from the surface visible in the selected pixel to the center of the image, along the X axis.
Y(mm)
Horizontal distance from the surface visible in the selected pixel to the center of the image, along the Y axis.
Z(mm)
Depth from the surface visible in the selected pixel to the face of the sensor.
Cursor(x,y)
Pixel coordinates of the selected pixel on the image sensor chip.

4.2 Connection Pane

Use the Connection pane parameters to change the sensor IP address and to connect to the sensor.
The default IP address for the ZMX sensor is 192.168.0.10.
The Banner 3D Configuration software remembers the IP address of the last connected sensor. The software also searches
the local Ethernet subnetwork to find any available sensors. These sensors are listed in the Connection pane.
Hover over to view sensor name, serial number, MAC address, Gateway, firmware version, etc. To change a sensor's IP
address, click .
To connect to a sensor, enter the IP address of the desired ZMX sensor into the Sensor IP Address field, then click
to the IP address. Alternately, locate the IP address of the desired sensor in the list of discovered sensors, then click
the Action column.
The model number of the sensor also displays.
To disconnect from a sensor, click
Click to reboot a connected sensor.

4.3 Sensor Controls Pane

Use the Sensor Controls pane parameters to set the trigger mode and illumination output.
Figure 12. Sensor Pane
.
Figure 13. Sensor Controls Pane
www.bannerengineering.com - Tel: + 1 888 373 6767
ZMX Series 3D Time of Flight Sensor
next
in
13