Power Led Light Goes Out - Ricoh fi-70F Operator's Manual

Power LED Light Goes Out

Check the following points
● Has the scanner been left out of operation for a long time after being powered on? (page
42)
If the problem still persists, check each item in
Provider (page 54)
product. Refer to the contact information in the Contact List if supplied with this product, or
refer to the contact information in the Contact for Inquiries section if provided in Safety
Precautions supplied with this product, and then make an inquiry.
●
Has the scanner been left out of operation for a long time after being powered on?
Solution
The scanner has entered power saving mode or has been automatically turned off.
● When the scanner has entered power saving mode
The power LED remains green.
Resume from power saving mode by one of the following methods:
- Press the [Power] or [Scan] button.
Do not press the [Power] button for 2 seconds or more.
Doing so turns off the scanner.
- Perform scanning from an application.
● When the scanner has been automatically turned off
The power LED is off.
Turn on the scanner.
For details, refer to
first, then contact the distributor/dealer where you purchased this
How to Turn the Power ON (page
42
Before You Contact the Scanner Service
19).
Troubleshooting