Entering And Resuming From Power Saving Mode - Ricoh fi-70F Operator's Manual

Entering and Resuming from Power Saving Mode

The scanner enters power saving mode when it is left on without being used for a certain period
of time.
Power saving mode keeps the power consumption low when the scanner has not been used for a
certain period of time.
Power saving mode has two types of settings.
● Power Save
If the scanner is left powered on for 15 minutes (factory default setting) or longer without being
used, it automatically enters power saving mode.
When the scanner enters power saving mode, the power LED remains green.
To resume from power saving mode, perform one of the following:
- Press the [Power] or [Scan] button.
Do not press the [Power] button for 2 seconds or more.
- Scan a document with the image scanning application.
● Auto Shutdown
The scanner is turned off automatically if it is left on without being used for a certain period of
time ([4 Hours] for the factory default setting).
To turn the power back on after the power is turned off automatically, press the [Power] button
or [Scan] button on the scanner. For details, refer to
ATTENTION
● When the scanner performs scanning for the first time after it resumes from power saving
mode, the scanning takes a longer time than usual because the scanner performs initialization
similar to that performed at power-on.
● For some image scanning applications, the scanner may not be turned off even if [Auto
Shutdown hours] is specified.
● If the scanner is automatically turned off while you are using the image scanning application,
exit the application, and then turn the scanner back on.
HINT
The waiting time for entering power saving mode can be changed in the Software Operation
Panel.
For details, refer to
(page 73).
Waiting Time for the Scanner to Enter Power Saving Mode [Power saving]
How to Turn the Power ON (page
24
Basic Operations
19).