P1, P2 Host Interface Connector; H1, H2 Host Interface Connector; H3, H4 Panel Interface Connector - Epson S5U13709P00C100 User Manual

Embedded memory graphics lcd controller

Hide thumbs Also See for S5U13709P00C100:

Table of Contents

4.1

P1, P2 Host Interface Connector

The S5U13709P00C100 Evaluation Board is designed to connect to a S5U13U00P00C100 USB Interface Board.

The USB Interface Board provides a simple connection to any computer via USB 2.0 connection. The

S5U13709P00C100 directly connects to the USB Interface Board through connectors P1 and P2.

When the S5U13709P00C100 is connected to the S5U13U00P00C100, there is a LED on the

S5U13U00P00C100 which provide a quick visual status of the power supply (5V). And S5U13709P00C100 has

a LED too. This LED indicates that the 3.3V power is supplied. P1 and P2 connectors are 2mm pitch, dual row,

and 40-pin female headers (20x2).

Note:

A windows driver must be installed on the PC when the S5U13709P00C100 is used with the S5U13U00P00C100

USB Interface Board. The S1D13xxxUSB driver is available at vdc.epson.com.

4.2

When the S5U13709P00C100 Evaluation Board connects with the S5U13U00P00C100 USB Interface Board, H1

and H2 connectors can be used as monitor terminals.

The S5U13709P00C100 is designed to connect to a S5U13U00P00C100. But H1 and H2 connectors allow a

variety of development platforms to be used with the S5U13709P00C100. When not used with the

S5U13U00P00C100, please supply the 5V power to TP1 terminal.

4.3

The LCD interface uses the FPFRAME, FPSHIFT, FPDRDY, FPLINE and FPDAT [3:0] pins. All signals on

these pins are available on connectors H3 and H4. Connectors H3 and H4 are 2.54mm pitch, dual row, and 40-pin

female headers (20x2).

S5U13709P00C100 Evaluation Board

(Rev.1.1)

Seiko Epson Corporation

Connectors

Table of Contents