Kikusui PLZ-5W Series User Manual page 82

Parallel operation using the same model
82
3
Remove the SYNC/PARALLEL port cover on the rear panel of the elec-
tronic load to be used as the master unit.
4
Connect a parallel operation signal cable to the PARALLEL OUT port,
and attach the SYNC/PARALLEL port cover.
5
Connect all the electronic loads to be operated in parallel with signal
cables.
Connect the PARALLEL OUT terminal and IN terminal with a parallel operation signal
cable. After connecting, be sure to attach the SYNC/PARALLEL port cover while refer-
ring to step4.
Connection example
PARALLEL OUT
Parallel operation
signal cable
PARALLEL IN
PARALLEL OUT
PARALLEL IN
This completes connection procedure.
M3×6
Parallel operation signal cable
6.Parallel Operation
MASTER
SLAVE
+
DUT
SLAVE
PLZ-5W