Products - Check Point UTM-1 U-5 Getting Started Manual

Wizard, you can remove this interface in the Interface Management > Network Interfaces
page.
DHCP Server - You can configure the Gaia appliance to be a Dynamic Host Configuration
Protocol (DHCP) server.
To define a DHCP server on the Gaia appliance INT interface:
1. In DHCP Server, select Enabled.
2. Define the IP Pool. This is the range of IPv4 addresses that the server assigns to hosts.

Products

Products
Select the Gaia products that are installed on the appliance.
Advanced
Use these options to configure an appliance that is a cluster member or in a High Availability
deployment.

Unit is part of a cluster - the options are:

ClusterXL - For more about ClusterXL configurations, see the applicable version of the
ClusterXL Administration Guide.

VRRP - For more about VRRP clusters, see the applicable version of the Gaia
Administration Guide.

Define Security Management as - In a Management High Availability deployment, define
this Security Management server as Primary or Secondary. For more about Management
18 | UTM-1 Getting Started Guide